NAME

       oss_digi96 - RME Digi96 professional audio driver.

DESCRIPTION

       Audio driver for the RME Digi96 family of profressional audio controllers.

       •  Only 16 and 24/32 bit audio formats are supported.

       •  All  Digi96  family  members  support  32kHz, 44.1kHz, 48kHz, 64kHz, 88.2kHz and 96kHz.
          sampling rates.

MIXER PANEL

       Note! For recording you need to set digi96.sync to INTERNAL and the values of  digi96.mode
       and  digi96.input  to  match  your  studio  setup. Otherwise recordings will fail with I/O
       error.

       There are several settings that can be changed using the ossmix program shipped with  OSS.
       Note  that  some features don't work with all Digi96 family members. For example ADAT mode
       is not supported by the base model.

       •  digi96.mode <SPDIF|AESEBU|ADAT>: This setting controls the output  mode  which  can  be
          S/PDIF  (consumer),  AES/EBU  (professional)  or  ADAT.  The  input  mode  is  detected
          automatically.  If ADAT input is detected the output mode  will  be  switched  to  ADAT
          automatically (this doesn't work in the other direction).

       •  digi96.sync  <EXTERNAL|INTERNAL>:  This  setting tells if the playback sampling rate is
          based on the internal oscillator or the sample rate detected in  the  input  port.  See
          also the definition of the digi96.worldclk setting.

       •  digi96.input <OPTICAL|COAXIAL|INTERNAL|XLR>: Selects the active input.

       •  digi96.sel <BYPASS|NORMAL>: When set to BYPASS the input signal will be routed directly
          to the output (also sets digi96.sync automatically to EXTERNAL).  In  this  mode  audio
          data written to /dev/dsp will be muted.

       •  digi96.worldclk  ON|OFF: Setting this control to ON will enable the optional worldclock
          input as the sample rate source (overrides the digi96.sync setting).

       •  digi96.emph ON|OFF: Enables/disables the de-emphasis option  on  the  analog  (monitor)
          output connector.

       •  digi96.data  <AUDIO|AC3>: Specifies if the output signal is audio or AC3 data (sets the
          non-audio bit in the channel status data).

OPTIONS

       None

FILES

       /etc/oss4/conf/oss_digi96.conf
              Device configuration file.

AUTHOR

       4Front Technologies

                                         11 February 2015                           oss_digi96(7)