NAME

       amttool - remotely control Intel AMT managed machines.

SYNOPSIS

       amttool host [ command ] [ arg(s) ]

DESCRIPTION

       amttool  is  a  perl script which speaks SOAP to Intel AMT managed machines.  It can query
       informations about the machine in question and also send some commands  for  basic  remote
       control.

       host  is  the hostname or IP address of the machine amttool should control.  command is an
       optional command.

       You must set fill AMT_PASSWORD environment variable with the AMT password.

       For more inforamtions on Intel AMT check amt-howto(7).

COMMANDS

       info   gather information (default).

       reset [ special ]
              reset machine, with optional special command (see section below).

       powerup [ special ]
              turn on machine.

       powerdown
              turn off machine.

       powercycle [ special ]
              powercycle machine.

       netinfo
              print network configuration (requires AMT 2.5+).

       netconf if link [ ip mask gw [ dns1 [ dns2 ]]]
              configure network interface (requires AMT 2.5+).  if is the interface handle,  link
              the  link policy.  If in doubt just feed in what the netinfo command prints.  ip is
              the IPv4 address, mask the netmask, gw the default gateway, dns1 and dns2  are  the
              DNS  Servers.   If no IP configuration is specified the tool tries to configure the
              machine in shared mac address mode with dhcp, otherwise  in  separate  mac  address
              mode  with static IP address.  Default for dns1 is the gateway address, for dns2 it
              is 0.0.0.0.

SPECIAL COMMANDS

       Special commands can optionally be specified for  reset,  powerup  and  powercycle.   They
       change the default boot behavior of the machine.

       bios   Asks for the BIOS boot messages being redirected to serial-over-lan.

       pxe    Network boot via PXE.

       hd     Boot from local disk.

       hdsafe Boot from local disk (safe mode).

       cd     Boot from CD/DVD.

       diag   Boot in diagnostics mode.

ENVIRONMENT

       AMT_PASSWORD
              AMT password.

       AMT_DEBUG
              Enable debug output.

SEE ALSO

       amtterm(1), gamt(1), amt-howto(7)

AUTHOR

       (c) 2007 Gerd Hoffmann <kraxel@redhat.com>

                                    (c) 2007,08 Gerd Hoffmann                          amttool(1)