NAME

       fence_xcat - I/O Fencing agent for xcat environments

SYNOPSIS

       fence_xcat [OPTION]...

DESCRIPTION

       fence_xcat is a wrapper to the rpower(1) command that is distributed with the xCAT project
       available at http://www.xcat.org.  Use of fence_xcat requires that xcat has  already  been
       properly  configured  for  your  environment.   Refer  to  xCAT(1) for more information on
       configuring xCAT.

       fence_xcat accepts options on the command line  as  well  as  from  stdin.   fenced  sends
       parameters  through  stdin  when it execs the agent.  fence_xcat can be run by itself with
       command line options which is useful for testing.

       NOTE: It is recommended that fence_bladecenter(8) is used instead  of  fence_xcat  if  the
       bladecenter firmware supports telnet.  This interface is much cleaner and easier to setup.

       Vendor URL: http://www.xcat.org

OPTIONS

       -h     Print out a help message describing available options, then exit.

       -n nodename
              The nodename as defined in nodelist.tab of the xCAT setup.

       -o action
              The action required.  on, off, reset (default) or stat.

       -r rpower
              The path to the rpower binary.

       -q     Quiet mode: print only error messages.

       -V     Print out a version message, then exit.

STDIN PARAMETERS

       agent = < param >
              This option is used by fence_node(8) and is ignored by fence_xcat.

       nodename = < param >
              The nodename as defined in nodelist.tab of the xCAT setup.

       action = < param >
              The action required.  on, off, reset (default) or stat.

       rpower = < param >
              The path to the rpower binary.

SEE ALSO

       fence(8), fence_node(8), fence_bladecenter(8), nodelist.tab(8), rpower(1), xCAT(1)

                                                                                    fence_xcat(8)