NAME

       front-end-cal - RF front-end center frequency and sampling rate calibration tool.

SYNOPSIS

       front-end-cal -config_file=<path-to-configuration-file> [OPTION]...

DESCRIPTION

       front-end-cal is a calibration tool for some DVB-T receivers based on the Taiwan's Realtek
       RTL2832U chipset, sold in form of USB dongles that allow users to watch over-the-air DVB-T
       European broadcast television on their personal computers, to be used as GNSS front-ends.

       Normally,  those  devices  send  partially-decoded MPEG transport frames over the USB, but
       exploiting an undocumented mode of operation of the demodulator chip, the user is able  to
       obtain  raw  I&Q  samples,  stream  them  through  USB to a personal computer and then use
       gnss-sdr, turning the DVB-T receiver into a  GNSS  receiver  and  delivering  position  in
       real-time.

       The  crystal  oscillator  that  ships  with  the  RTL2832U family devices exhibits limited
       accuracy  to  be  used  as  a  GNSS  receiver  front-end  without  previous   calibration.
       front-end-cal  implements  the  algorithm proposed in [1], and it requires Internet access
       since it retrieves Assisted GPS data from SUPL servers.

       front-end-cal is able to work with raw data files or,  if  there  is  computational  power
       enough,  in  real  time  with  suitable  radio frequency front-ends. The whole receiver is
       defined in a single configuration file, and therefore users can define theirs.

OPTIONS

       front-end-cal takes the following options:

       -config_file=<path-to-configuration-file> Set the configuration file.

       -signal_source=<path-to-raw-signal-file> If defined,  path  to  the  file  containing  the
       signal samples (overrides the data file specified in the configuration file).

       -log_dir=<path-to-directory>  If  defined,  overrides the default directory where logs are
       saved.

       -version Print program version and exit.

       -help Print all the available commandline flags and exit.

SEE ALSO

       gnss-sdr(1),volk_gnsssdr_profile(1)

       Example          of          configuration          file           available           at:
       ${prefix}/share/gnss-sdr/conf/front-end-cal.conf,  where  ${prefix}$  uses  to  be /usr or
       /usr/local. This will be the configuration file used by default if the -config_file option
       is not set.

       [1] C. Fernandez-Prades, J. Arribas, P. Closas, Turning a Television into a GNSS Receiver,
       in Proceedings of ION GNSS+, 15-16 September 2013, Nashville,  Tennessee  (USA).  A  draft
       copy                 is                 freely                 available                at
       http://www.cttc.es/publication/turning-a-television-into-a-gnss-receiver/

       Check http://gnss\-sdr.org for more information.

BUGS

       No known bugs.

AUTHOR

       Javier Arribas (javier.arribas@cttc.es)

       This software has been developed  at  CTTC  (Centre  Tecnologic  de  Telecomunicacions  de
       Catalunya, http://www.cttc.es) with contributions from around the world.