xenial (1) setfdprm.1.gz

Provided by: fdutils_5.5-20060227-7_amd64 bug

Name

       setfdprm - sets user-provided floppy disk parameters

Note

       This  manpage  has  been  automatically  generated  from  fdutils's texinfo documentation.  However, this
       process is only approximative, and some items, such as cross-references, footnotes and indices  are  lost
       in  this  translation  process.   Indeed,  these  items have no appropriate representation in the manpage
       format.  Moreover, only the items specific  to  each  command  have  been  translated,  and  the  general
       information about fdutils has been dropped in the manpage version.  Thus I strongly advise you to use the
       original texinfo doc.

       *      To generate a printable copy from the texinfo doc, run the following commands:

                     ./configure; make dvi; dvips fdutils.dvi

       *      To generate a HTML copy,  run:

                     ./configure; make html

              A pre-made HTML can be found at: `http://www.tux.org/pub/knaff/fdutils'

       *      To generate an info copy (browsable using emacs' info mode), run:

                     ./configure; make info

       The texinfo doc looks most pretty when printed or as HTML.  Indeed, in the info version certain  examples
       are difficult to read due to the quoting conventions used in info.

Description

          setfdprm [-p] device media-description

          setfdprm [-c | -y | -n] device

       setfdprm is a utility that can be used to load disk parameters into the auto-detecting floppy devices and
       "fixed parameter" floppy devices, to clear old  parameter  sets  and  to  disable  or  enable  diagnostic
       messages.  These parameters are derived from a media-description, see section  Media description for more
       details.

       Without any options, setfdprm loads the  device  (for  example  `/dev/fd0'  or  `/dev/fd1')  with  a  new
       parameter  set  with  the  name  entry  found  in  `/etc/mediaprm'  (usually  named  360/360, etc.).  For
       autodetecting floppy devices, these parameters stay in effect until the  media  is  changed.  For  "fixed
       parameter" devices, they stay in effect until they are changed again.

       Setfdprm can also be used by the superuser to redefine the default formats.

Options

       -p device name
              Permanently  loads  a  new  parameter set for the specified auto-configuring floppy device for the
              configuration with name in `/etc/mediaprm'. Alternatively, the parameters can  be  given  directly
              from the command line.

       -c device
              Clears the parameter set of the specified auto-configuring floppy device.

       -y device
              Enables format detection messages for the specified auto-configuring floppy device.

       -n device
              Disables format detection messages for the specified auto-configuring floppy device.

Media description

       Please see the Media description section in the full fdutils documentation:
       - Texinfo documentation (info fdutils)
       - HTML documentation in /usr/share/doc/fdutils/Fdutils.html
       - or DVI documentation in /usr/share/doc/fdutils/Fdutils.dvi.gz

Bugs

       This documentation is grossly incomplete.

See Also

       Fdutils' texinfo doc