bionic (5) systemd.kill.5.gz

Provided by: systemd_237-3ubuntu10.57_amd64 bug

NAME

       systemd.kill - Process killing procedure configuration

SYNOPSIS

       service.service, socket.socket, mount.mount, swap.swap, scope.scope

DESCRIPTION

       Unit configuration files for services, sockets, mount points, swap devices and scopes share a subset of
       configuration options which define the killing procedure of processes belonging to the unit.

       This man page lists the configuration options shared by these five unit types. See systemd.unit(5) for
       the common options shared by all unit configuration files, and systemd.service(5), systemd.socket(5),
       systemd.swap(5), systemd.mount(5) and systemd.scope(5) for more information on the configuration file
       options specific to each unit type.

       The kill procedure configuration options are configured in the [Service], [Socket], [Mount] or [Swap]
       section, depending on the unit type.

OPTIONS

       KillMode=
           Specifies how processes of this unit shall be killed. One of control-group, process, mixed, none.

           If set to control-group, all remaining processes in the control group of this unit will be killed on
           unit stop (for services: after the stop command is executed, as configured with ExecStop=). If set to
           process, only the main process itself is killed. If set to mixed, the SIGTERM signal (see below) is
           sent to the main process while the subsequent SIGKILL signal (see below) is sent to all remaining
           processes of the unit's control group. If set to none, no process is killed. In this case, only the
           stop command will be executed on unit stop, but no process be killed otherwise. Processes remaining
           alive after stop are left in their control group and the control group continues to exist after stop
           unless it is empty.

           Processes will first be terminated via SIGTERM (unless the signal to send is changed via
           KillSignal=). Optionally, this is immediately followed by a SIGHUP (if enabled with SendSIGHUP=). If
           then, after a delay (configured via the TimeoutStopSec= option), processes still remain, the
           termination request is repeated with the SIGKILL signal (unless this is disabled via the SendSIGKILL=
           option). See kill(2) for more information.

           Defaults to control-group.

       KillSignal=
           Specifies which signal to use when killing a service. This controls the signal that is sent as first
           step of shutting down a unit (see above), and is usually followed by SIGKILL (see above and below).
           For a list of valid signals, see signal(7). Defaults to SIGTERM.

           Note that, right after sending the signal specified in this setting, systemd will always send
           SIGCONT, to ensure that even suspended tasks can be terminated cleanly.

       SendSIGHUP=
           Specifies whether to send SIGHUP to remaining processes immediately after sending the signal
           configured with KillSignal=. This is useful to indicate to shells and shell-like programs that their
           connection has been severed. Takes a boolean value. Defaults to "no".

       SendSIGKILL=
           Specifies whether to send SIGKILL to remaining processes after a timeout, if the normal shutdown
           procedure left processes of the service around. Takes a boolean value. Defaults to "yes".

SEE ALSO

       systemd(1), systemctl(1), journalctl(8), systemd.unit(5), systemd.service(5), systemd.socket(5),
       systemd.swap(5), systemd.mount(5), systemd.exec(5), systemd.directives(7), kill(2), signal(7)